The lifespan of your tire is dependent on a couple of factors which include: the driver, the type of vehicle, the road type and the rate at which traveling is done.
However, one essential point which must be noted is, for the proper protection of your vehicle and the tires’ durability, there is a need to maintain a good level of the pressure in the vehicle’s tire.
If the air pressure of the tire is regularly low, it would not only reduce the lifespan of the tire, it also has the tendency to cause adverse outcomes. It could cause an accident, and it could also make the tires wear out faster than usual.
Also, there is a high possibility that more than usual gasoline, would be used.
Hence, there is a need for the driver to know how to verify the pressure in the tire of a vehicle, and how to fill the tires with air.
REGULARLY USED METHODS TO PUT AIR IN TIRES
There are some cases whereby there would be no gauge available, and there would be a need to put air in tires.
It could be quite herculean to figure out.
However, with a certain level of experience, you would be able to detect the precise air pressure level in the tire.
The below methods are commonly used in putting air inside tires without having to use a gauge:
- The Eyeball method: This is basically done by having a good look at the tire pressure of the vehicle from a distance. Hence, to perfectly achieve this purpose, you would need to position the vehicle on a flat road. This method is however regarded as being risky. There could also be a danger of inflating excessively
- The Hand pressure method: With this method, what you have to do, is to use your hand to push the tire in a forceful manner. If it is very hard, as would rock, then the air inside the tire is plentiful. However, if it pushes back, the pressure in the tire is low. So, what you need to do, is to put air until it is very hard like a rock.
- Mud ride test: This method is quite long, as you would require a level of careful observation to get the right result. You would start by applying mud on the tires, then create a mark on the floor by moving the vehicle a little. Take a cautious observation of the trail, and compare with how the tire touches the surface. A tire which has less air would definitely be different, and grubby when compared to other tires.
So, what you need to do, is to fill the tire with air, until it reaches the required car tire pressure.
- The thumb adjustment method: This method has a striking similarity to the hand pressure method, as it can be used as a benchmark to check if the air pressure of the tire is low.
- The bulk on the wheels method: This method requires you to place extreme weight on the tires. Those which have low pressure would undergo deformation of about 10-20%. With this, you would be able to figure out the amount of air to put in the tires of your vehicle.